Ceiling Fan Remote Not Working Light

If you have an older ceiling fan the switch may be worn out.

Ceiling fan remote not working light.

Check to see whether you have loose switch wiring. You can do this by pointing it towards the camera of your phone and then pressing and holding a button. Make sure the switch isn t in between positions. Confirm the reverse switch is not in a neutral position.

The battery in the remote control needs replacing. If the fan won t turn on and the lights are working then there is power to the fan. Follow the steps below to determine the cause. See the links below to go to the ceiling fan area for detailed photos and instructions.

Should it become necessary to re sync the remote turn off the main power then turn it back on. If you see black or burned areas this may be a sign that your ceiling fan light kit has a wiring issue. So if the pull chain is in the off position the remote control will not be able to get any power to the ceiling fan light or fan. Flip the switch several times to make sure it is the right.

If no light is visible then it is busted. Yes the ceiling fan remote control module may be faulty. Within 30 seconds use a small screwdriver to press and hold the learn button on the remote for 3 seconds. If you are using a remote or.

Check whether you have a faulty connection somewhere between the switch fan and circuit breaker. Look inside of the light bulb socket to make sure there are no burn marks or charred spots. The pull chain switches are in the wrong setting. This can usually be done by checking the dip switches.

The fan will turn on and light if applicable will blink three times signaling a successful synchronization. They need to be set the same way on both the fan and the remote. One way to know for sure would be to remove the receiver module at the ceiling fan and wire it direct. The light bulbs in the fixture are burnt out.

Other conditions that may prevent a ceiling fan from working. In this case you will need to purchase a new remote and program it for the ceiling fan receiver. Screw them into. Check whether you have loose ceiling fan wiring.

If things look good return light bulbs that are in working order into their sockets. If the ceiling fan and light works normally then the remote control module will need to be replaced. If the remote light up on the camera viewfinder it is working perfectly. Check the reversing switch.